24/7 EMERGENCY
Burst pipe? Boiler down? No hot water? Engineers on call right now —
Mon–Fri 8am–6pm · Sat 9am–5pm ·
Emergency line open 24/7
Gas Safe Reg: 123456
Trustpilot 4.9★
24/7 EMERGENCY
Burst pipe? Boiler down? No hot water? Engineers on call right now —
Emergency line open 24/7
Gas Safe Reg: 123456
Trustpilot 4.9★
Brilliant Plumbing installs outside garden taps across the London Borough of Richmond upon Thames — from the larger gardens of Richmond, Twickenham and Teddington, to riverside gardens in Barnes, and the courtyards and rear yards of period conversions in Kew and St Margarets. Every tap is fitted with an isolation valve as standard, at a fixed price, with a 12-month guarantee on every job.
TW1
TW2
TW9
TW10
TW11
Richmond upon Thames’s gardens and outdoor spaces vary as much as its housing — from the larger rear gardens of Richmond, Twickenham and Teddington, to riverside plots in Barnes and the compact courtyards of period conversions in Kew and St Margarets. Our engineers size and route every installation to suit the property.
The bigger rear gardens typical of Richmond, Twickenham and Teddington's townhouses are ideal candidates for a garden tap, often run some distance from the house. We route pipework neatly and insulate any external run against frost.
Riverside properties in Barnes often have gardens running down toward the Thames, sometimes needing a longer or more carefully routed pipe run. We advise on the best position during survey to suit the garden layout.
Period conversions in Kew and St Margarets often have smaller rear yards or courtyard gardens. A single, well-placed outside tap close to the back door is usually all that's needed, with minimal pipe run and disruption.
Ground-floor flats and maisonettes around East Sheen with a small patio or yard can still have a garden tap fitted, subject to leaseholder permissions where relevant. We advise on the simplest routing from the internal supply.
Most outside tap installations are straightforward — but a few details affect the price and the finished job. Our engineer will always confirm these on survey before any work begins.
Ideally close to an internal wall with an accessible supply pipe behind it, to keep the external run short and minimise drilling.
Yes — fitted as standard on every installation, so the outside tap can be shut off and drained separately ahead of winter.
Any external pipework is lagged as standard, and we advise draining the tap down over winter to avoid burst pipes in cold snaps.
Yes — outside taps are supplied from the mains cold feed, so they work the same way regardless of your boiler or heating system type.
Often, yes — we recommend checking your lease or with your freeholder before booking, particularly for flats around East Sheen and Kew.
Yes — many customers start with one tap and add a second at the far end of a larger garden at a later date, particularly in Richmond and Teddington.
Standard single-tap installations are fixed-price jobs confirmed before we start. Longer pipe runs or additional taps are quoted after a brief assessment.
Supply & fit with isolation valve, short internal run
Reseal or replace a leaking joint
Additional tap fitted at the same visit
Add a valve to an existing outside tap
Insulate external pipework against winter freezing
Fix leaking or seized existing tap
Remove an unwanted outside tap and cap the supply
Multiple taps or unusual routing — quoted after survey
All standard cleaning and single-section repairs are fixed-price, confirmed before work begins — no call-out charge. 12-month workmanship guarantee on every job.
A complete installation, from choosing the right system to a fully tested.
We identify the nearest suitable internal supply, agree the best position for the tap, and check the route the pipework will take.
Your engineer confirms the fixed price for the job before starting — including the isolation valve as standard. No work begins until you're satisfied.
We drill through the wall, run and lag the pipework, and fit the tap and isolation valve, keeping disruption to a minimum inside and out.
We turn the water on, check for leaks at every joint, and talk you through using the isolation valve ahead of winter.
Every outside tap we install includes an isolation valve, so it can be shut off and drained independently — protecting against winter freeze damage.
From Richmond and Twickenham's larger gardens to Barnes's riverside plots and Kew's courtyards, we route pipework to suit the property, not a one-size-fits-all approach.
The same fixed pricing applies whether you're in Richmond or Hampton. No zone uplift, no call-out charge, ever.
Most outside tap installations are completed in one visit, with minimal mess and the work area left clean — inside and out.
Read all reviews on Trustpilot →
“Wanted an outside tap at the far end of our Richmond garden for watering without dragging a hose through the house. The engineer routed the pipework neatly, insulated the run, and fitted an isolation valve so we can drain it down over winter.”
“Riverside garden in Barnes needed a longer run than usual — the engineer planned the route carefully and it looks completely unobtrusive. No mess, exactly as quoted.”
“Ground-floor flat near East Sheen with a small patio — engineer checked our lease requirements with us first, then fitted the tap cleanly with an isolation valve. Straightforward and fairly priced.”
Yes. We cover the entire borough including Richmond, Twickenham, Teddington, Barnes, East Sheen and Kew — postcodes TW1, TW2, TW9, TW10, TW11 and TW12. Our engineers are based locally across South West London for fast response throughout the area.
Yes. We regularly install outside taps for gardens running down toward the Thames in Barnes and along Twickenham Riverside, planning the route to suit the garden layout and any longer distances involved.
Same-day across TW1, TW2, TW9, TW10, TW11 and TW12. Fixed price before we start. 12-month guarantee on every job.
We also cover these neighbouring boroughs — same fixed prices, same-day availability.