24/7 EMERGENCY
Burst pipe? Boiler down? No hot water? Engineers on call right now —
Mon–Fri 8am–6pm · Sat 9am–5pm ·
Emergency line open 24/7
Gas Safe Reg: 123456
Trustpilot 4.9★
24/7 EMERGENCY
Burst pipe? Boiler down? No hot water? Engineers on call right now —
Emergency line open 24/7
Gas Safe Reg: 123456
Trustpilot 4.9★
We install, replace and repair radiators across Lambeth — from cold-spot diagnosis in Clapham and Brixton to full system powerflushes in older Streatham properties. New radiators, TRVs, bleeding and balancing, all at a fixed price with no call-out charge.
SW2
SW4
SW8
SW9
SE11
SE24
SE27
🔒 No obligation. Fixed price confirmed before any work starts.
Trustpilot rating 1,800+ verified reviews
From single cold radiators to whole-house heating issues, these are the problems we’re called out for most often across Lambeth.
Trapped air is the most common cause, stopping hot water circulating through the top of the radiator. Usually resolved by bleeding, but persistent air can point to a bigger system issue.
Sludge and debris settling at the base of the radiator restrict flow and reduce heat output — common in Lambeth properties on older, un-flushed heating systems.
Could be a stuck valve, a balancing issue, or a blocked pipe run — particularly common in Clapham and Brixton properties with original period pipework.
Leaks typically come from a worn valve or a corroded radiator body, while banging or gurgling noises usually point to trapped air or sludge moving through the system.
Correct diagnosis first, so you’re not paying for a powerflush when a bleed and a new valve would fix it — or vice versa.
Your engineer checks each affected radiator, valve and the wider system to identify whether the issue is trapped air, sludge, a faulty valve, or a balancing problem.
Depending on diagnosis, this may mean bleeding, replacing a valve, fitting a new radiator, or a full system powerflush to remove built-up sludge.
Once repairs are complete, radiators are balanced against each other so heat is distributed evenly across the whole property, not just the nearest radiator to the boiler.
The heating system is run through a full cycle to confirm even heat output before we finish, with any follow-up maintenance explained.
Radiator problems rarely stay isolated — they tend to affect boiler efficiency and heating bills across the whole property.
Sludge-clogged radiators force the boiler to work harder for the same output, increasing energy use across Lambeth properties on older systems.
A dirty heating system puts unnecessary strain on the boiler's pump and heat exchanger — a powerflush protects the most expensive part of your heating system.
Balancing stops one radiator hogging the heat while others in Lambeth bedrooms and living rooms stay cold, evening out comfort across the house.
Thermostatic radiator valves let you set different temperatures per room, avoiding heating unused rooms and reducing overall energy use.
Cost depends on the number of radiators affected and the work required. All prices confirmed before we attend — no call-out charge.
Diagnostic visit and air release
Like-for-like swap, existing pipework
New position, pipework extended
Thermostatic radiator valve fitted
Whole-house sludge removal
Whole-house heat distribution check
Fast arrival across all Lambeth postcodes without the delays of London-wide dispatch, from Clapham to Brixton and Streatham.
We identify the actual cause — air, sludge, a faulty valve or a balancing issue — rather than defaulting to the most expensive fix.
Clapham and Brixton's period properties often run original pipework that needs careful handling during radiator work and powerflushing.
The same fixed pricing applies whether you're in SW4 Clapham or SE27 West Norwood — no zone uplift, no call-out charge, no extras added after the fact.
We install and service radiators from all leading manufacturers, and can advise on the right type and output for each room.
All radiator work in Lambeth carries our 12-month guarantee, issued in writing on the day of completion.
Read all reviews on Trustpilot →
“Living room radiator had been cold at the bottom for months, assumed we’d need a new one. Turned out to be sludge and a full powerflush sorted every radiator in the house, not just the one.”
“Old cast iron style radiator in the hallway of our Brixton house had started leaking from the valve. Replaced with a modern equivalent that matched the room’s heat output, quick and tidy job.”
“Wanted TRVs on every radiator so we could stop heating rooms we weren’t using. Fitted across the whole house in one visit and explained how to set each one properly.”
Yes. We cover the entire Lambeth borough — SW2, SW4, SW8, SW9, SE11, SE24 and SE27 — including Clapham, Brixton, Vauxhall, Kennington, Herne Hill and Streatham, with no zone surcharge.
A bleed and inspection visit starts from £85, single radiator replacement from £190, and a new installation from £280. TRVs are £65 per valve, and a full system powerflush starts from £380. All prices confirmed before work begins.
If a radiator is cold at the top, it's usually trapped air and just needs bleeding. If it's cold at the bottom or across the whole radiator, sludge build-up is more likely, and a powerflush is the appropriate fix.
A full system powerflush typically takes 4–6 hours depending on the number of radiators and the level of sludge build-up, and is usually completed in a single visit.
Yes, in most cases. Thermostatic radiator valves let you heat only the rooms in use to the temperature you want, rather than every radiator running at the same setting.
In most cases, yes — a like-for-like replacement uses the existing pipe connections. If you're changing size, type or position, we'll advise on any pipework changes needed during the visit.
Same-day callouts, fixed price agreed before we start. Call now or book online.
We also cover these neighbouring boroughs — same fixed prices, same-day availability.