24/7 EMERGENCY
Burst pipe? Boiler down? No hot water? Engineers on call right now —
Mon–Fri 8am–6pm · Sat 9am–5pm ·
Emergency line open 24/7
Gas Safe Reg: 123456
Trustpilot 4.9★
24/7 EMERGENCY
Burst pipe? Boiler down? No hot water? Engineers on call right now —
Emergency line open 24/7
Gas Safe Reg: 123456
Trustpilot 4.9★
We install water softener systems across Ealing — from period terraces in Ealing town centre to family homes in Greenford and Northolt — removing hard water, reducing limescale build-up and protecting your boiler and appliances. Supply and install, or install-only if you’ve already chosen your system. Fixed price, clean installation, all Ealing postcodes covered.
W5
W13
UB1
UB2
UB5
UB6
🔒 No obligation. Fixed price confirmed before any work starts.
Like most of the capital, Ealing is supplied by Thames Water from sources that give London some of the hardest mains water in the country. Here are the four most common and costly problems it causes.
Limescale accumulates on taps, shower heads, tiles and kettles across Ealing homes, requiring constant descaling and leaving fixtures stained within weeks if the water isn’t treated.
Limescale narrows the internal bore of pipework over time, especially in hot water pipes where scale build-up is accelerated by temperature — reducing flow and efficiency.
Washing machines, dishwashers, electric showers and combi boilers in Ealing’s hard-water postcodes suffer accelerated wear, increasing energy use and causing early component failure.
Hard water reacts with soap and shampoo to form scum rather than lather. Many Ealing residents notice drier skin and duller hair directly linked to mineral-rich mains water.
A complete installation — from system selection through to full commissioning and optimisation — carried out in a single visit at a fixed price.
Your plumber assesses existing pipework, identifies the mains inlet, and determines the best installation position — typically under the kitchen sink, utility room, garage or basement, common across Ealing's mix of flats and larger houses.
For supply and install bookings, we recommend the right capacity and regeneration type for your property size and Ealing's water hardness. Brand-independent advice from leading manufacturers.
The softener is installed on the mains inlet and connected to drain for regeneration, with a bypass valve fitted as standard. All connections meet current water regulations.
The unit is commissioned to Ealing's local water hardness settings, the regeneration schedule configured, and a full test cycle run before handover.
Four measurable improvements from the day it’s commissioned — all compounding over time as limescale is progressively removed.
Softened water deposits no new limescale, and existing scale dissolves progressively — restoring flow and protecting older pipework common in Ealing and West Ealing properties.
Washing machines, dishwashers, showers and boilers all last longer on softened water — most manufacturers recommend it in hard water areas like Ealing.
Softened water lathers better and leaves no scum or staining — noticeable from first use, particularly for showering and washing up.
Descaling products, replacement showerheads and early appliance replacement are recurring costs in Ealing's hard water postcodes — a softener removes the cause, not just the symptoms.
Cost depends on whether you supply the unit, pipework complexity, installation location and system size. All prices confirmed before we attend — no call-out charge.
Standard under-sink or utility room installation
1–2 bed property, standard flow rate
3–4 bed property, twin or duplex system
5+ bed property or high-demand installation
Remove old unit, install new, reconnect
Check resin, regeneration cycle, connections
Fast arrival across all Ealing postcodes without the delays of London-wide dispatch, from Ealing town centre to Southall and Northolt.
Ealing town centre and West Ealing contain a number of Victorian and Edwardian houses. Our engineers fit discreet, low-impact installations that respect original pipework and fittings.
Water softener installation must comply with WRAS and Water Supply Fittings Regulations, including bypass valve, air gap and backflow prevention — done correctly on every job.
The same fixed pricing applies whether you're in W5 Ealing or UB1 Southall — no zone uplift, no call-out charge, no extras added after the fact.
We supply Harvey, Kinetico, BWT and other leading systems, recommending based on your Ealing property and water hardness — not brand preference.
All water softener installation work in Ealing carries our 12-month guarantee, issued in writing on the day of installation.
Read all reviews on Trustpilot →
“We’d been through three electric showers in eight years — all failed due to limescale on the elements. Had a water softener installed in the utility room and the current shower is still running perfectly two years later. Very neat installation, minimal ongoing salt cost.”
“Victorian terrace in West Ealing with genuinely awful limescale on every tap and the shower screen constantly needing scrubbing. Supply and install of a mid-tier system, and within a few weeks everything looked clean again.”
“Already had a softener bought online, just needed it fitted properly under the sink in our Greenford house. Explained the bypass and salt settings clearly and the job was done in under three hours.”
Yes. We cover the entire Ealing borough — W5, W13, UB1, UB2, UB5 and UB6 — including Ealing town centre, West Ealing, Southall, Northolt and Greenford, with no zone surcharge.
Install-only (customer-supplied unit) starts from £200. Supply and install starts from £650 for an entry-tier unit, £950 for a mid-tier unit, and from £1,400 for a premium system. Annual servicing starts from £99. All prices confirmed before work begins.
Yes. Ealing is supplied by Thames Water at 250–300 mg/l (as CaCO₃), classified as hard to very hard — consistent with most of the capital.
Yes. Our engineers are experienced with discreet, low-impact installations that respect original pipework and fittings in Ealing's older housing stock.
In Ealing's hard water areas, a typical 3–4 bedroom household uses approximately 2.5 to 4 kg of salt per week. Most units have a 15–25 kg capacity, meaning roughly monthly topping up. We configure the regeneration schedule for your usage during commissioning.
Yes, for most adults. Current guidelines recommend against using softened water for babies' formula or by those on a medically supervised low-sodium diet — so we fit a bypass to the cold kitchen tap as standard, giving access to unsoftened mains water if preferred.
No call-out charge. Fixed prices. Engineer dispatched in minutes across all Ealing postcodes. 24/7, 365 days a year.
We also cover these neighbouring boroughs — same fixed prices, same-day availability.